Back to Contents Page

Modem

Dell™ Latitude™ D505 Service Manual


Removing the Modem

CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.
  1. Follow the instructions in "Preparing to Work Inside the Computer."

  2. Remove the keyboard.

  3. Disconnect the display cable from the display cable connector on the system board.

  4. Remove the M2 x 3-mm screw.

1

modem cable

 

4

pull-tab

 

2

modem

Y0231

5

modem connector on system board

 

3

M2 x 3-mm screw

4270E

 

 

 

  1. Pull up on the pull-tab to disconnect the modem from the modem connector on the system board.

NOTICE: Do not disconnect the modem cable from the system board.
  1. Disconnect the modem cable from the modem.

Installing the Modem

  1. Connect the modem cable to the modem.

  2. Slip the left end of the modem and the modem cable underneath the metal modem-securing clip.

NOTICE: Ensure that the modem cable is routed correctly when you replace the modem.
  1. Ensure that the modem cable is properly routed under its routing clip.

NOTICE: Do not press down on the left side of the modem while installing it.
  1. Align the connector on the bottom of the modem with the modem connector on the system board and then press down on the right side of the modem to seat both connectors.

1

modem

Y0231

2

modem-cable routing clip

 

3

modem cable

 

4

modem-securing clip

 

  1. Replace the M2 x 3-mm screw.

  2. Reconnect the display cable to the display cable connector and then secure the display cable in its three display-cable routing clips.


Back to Contents Page