Cisco 2950 Switch Configuration
I set up a Cisco 2950 network switch this weekend using the
Basic Management Setup process, which consists of answering a series
of short questions posed by the switch in order to create a basic configuration
for the switch. The steps are listed
here.
[/hardware/network/switch/cisco]
permanent link
Enabling SSH on a Juniper NetScreen Firewall
To enable
SSH on a Juniper
NetScreen firewall through its web interface, take the following steps:
- Click on Configuration.
- Click on Admin.
- Click on Management.
- Check the box next to Enable SSH (V2).
- If you wish to change the port from the default value of
22, put in the value you wish to use in the Port field.
- If you also wish to enable
Secure Copy (SCP),
check the box next to Enable SCP.
- Click on the Apply button.
The above steps will allow access from the "trust" side of the firewall,
e.g. the Local Area Network (LAN) behind the firewall. If you want to permit
access from the "untrust" side, i.e. from the outside interface of the firewall,
you will have to take additional steps.
To permit access from the "unstrust" side using the web interface to
the firewall, take the following steps.
- Click on Network.
- Click on Interfaces.
- Click on the Edit link for the "untrust" zone.
- Under Service Options, check SSH.
- Click on OK.
[/security/firewalls/netscreen]
permanent link
Settings for Sony DSC-P92 for Auction Photos
A family member is putting a lot of items up for auction and needed to
take pictures of the items with our Sony model number DSC-P92 digital
camera. I had to play around with various settings on the camera
the last time she put up items for auction to find the best settings.
Unfortunately, I couldn't find the notes I made then, so had to go through
the same process again today with the camera, so I decided today I would
make a note on my blog of the settings she felt produced the best results of
those I tried today, so I've posted them
here.
[/hardware/camera]
permanent link
