MoonPoint Support Logo


Shop Amazon Warehouse Deals - Deep Discounts on Open-box and Used ProductsAmazon Warehouse Deals

Advanced Search
Sun Mon Tue Wed Thu Fri Sat

Tue, Jan 06, 2015 10:13 pm

Configuring Juniper NetScreen firewall rule from command line

I needed to configure an old Juniper Networks 5XP firewall from a command line interface, so that I could block all access to the Internet from that system, but, since it had been a very long time since I set a rule in one of those firewalls from its command line interface, which is accessible via SSH, it took me some time to get the syntax right for the command after realizing I had to associate the IP address with a name that I could use in the policy for the system first.

[ More Info ]

[/security/firewalls/netscreen] permanent link

Valid HTML 4.01 Transitional

Privacy Policy   Contact

Blosxom logo